NYSEG (Electric) - Commercial and Industrial Efficiency Program (New York)
This is the approved revision of this page, as well as being the most recent.
Last modified on February 12, 2015.
Financial Incentive Program
|Name||NYSEG (Electric) - Commercial and Industrial Efficiency Program|
|Incentive Type||Utility Rebate Program|
|Applicable Sector||Agricultural, Commercial, Fed. Government, Industrial, Institutional, Local Government, Nonprofit, State Government, Tribal Government|
|Eligible Technologies||Central Air conditioners, Chillers, Custom/Others pending approval, Heat pumps, Lighting, Lighting Controls/Sensors, Programmable Thermostats|
|Energy Category||Energy Efficiency Incentive Programs|
|Amount|| Lighting, HVAC: Prescriptive incentives vary|
A/C or Heat Pump < 63 tons: $50-$100/ton
|Eligible System Size|| Prescriptive rebates listed in this table are available to all non-residential customers of the company who pay the systems benefits charge.
Pre-approval is required for prescriptive applications with total rebate value greater than $10,000.
|Equipment Requirements|| A/C and Heat Pump (11.25-19.9 tons): 11.5 -12.0 EER|
A/C and Heat Pump (20-62.9 tons): 10.5 -10.8 EER
|Installation Requirements||New construction projects are not eligible for rebates.|
|Maximum Incentive||No maximum per customer rebate; however, NYSEG/RG&E reserve the right to cap the rebate to any one customer.|
NYSEG and RG&E offer rebates to non-residential customers installing energy efficient equipment that have an electricity Systems Benefits Charge (SBC) included in their energy bills. Both prescriptive rebates and custom incentives are available. These rebates are being offered due to the June 2008 New York State Public Service Commission order to meet New York's Energy Efficiency Portfolio Standard. The goal is to reduce statewide energy use 15% by 2015.
Custom incentives are available when energy efficiency improvements require site-specific engineering and cost analysis. Any nonresidential NYSEG or RG&E electricity customer is eligible, and customers can select their own contractor to install equipment.
If standard rebate or custom projects meet the eligibility requirements specified on the individual application forms, then participants should submit equipment specification sheets, equipment inventory sheets, building plans and invoices with the application. NYSEG or RG&E may require a pre-installation inspection. After approval of the application, NYSEG or RG&E will authorize payment in 6-8 weeks. Pre-approval is required for all custom applications, and for standard rebate applications of more than $10,000.
|Contact Name||C&I Rebate Program|
|Address||301 Plainfield Road, Suite 150|
|Place||Syracuse, New York|
|Phone 2||(888) 316-8023|
- Incentive and policy data are reviewed and approved by the N.C. Solar Center's DSIRE project staff.